少妇人妻无码专区毛片_蝌蚪视频窝在线播放_欧美性色欧美A在线播放_尤物在线精品视频_欧美精品国产一区二区三区_在线观看成人无码中文AV天堂不卡

SCR-210A015U01_SCR-210A012U01_SCR-210A014U01_SCR19Z-M功率控制器OMEGA歐米茄

SCR19系列SCR功率控制器僅用于將電力與電阻負載（如烤箱、熔爐、熱封器等）進行比例分配（注：它們不用于驅動變壓器或任何感應負載）。

SCR19系列控制器提供兩種比例控制方法-零電壓切換和相位角點火。在零電壓切換模式下，控制器打開交流電源電壓的完整循環。觸發電路設計為盡可能接近交流正弦波穿過零點的點打開SCR。實際上，線路電壓是開著和關著的，并在整個循環中施加到加熱器上。

SCR-210A015U01_SCR-210A012U01_SCR-210A014U01_SCR19Z-M功率控制器OMEGA歐米茄

The SCR19 Series SCR Power Controllers are designed to proportion electric power to resistive loads only, such as ovens, furnaces, heat sealers, etc. (NOTE: They are not designed to drive transformers or any inductive load.) 

These heater controllers consist of power semi-conductors (SCRs), properly-sized heat sinks, trigger circuitry, and fuses supplied on panels for surface mounting. The SCR power controller accepts a 4 to 20 mA dc output from a temperature controller or can be supplied with manual option using a remote potentiometer. 

The SCR19 Series controllers offers two methods of proportional control – Zero-voltage-switched and Phase-angled-fired. With the Zero-voltage-switching mode, the controller switches on complete cycles of the ac supply voltage. The trigger circuit is designed to turn on the SCRs as close as possible to the point where the AC sine wave crosses through zero. In effect, the line voltage is turned on and off and applied to the heaters in whole cycles. 

SCR-210A015U01_SCR-210A012U01_SCR-210A014U01_SCR19Z-M功率控制器OMEGA歐米茄

SCR19系列控制器提供兩種比例控制方法-零電壓切換和相位角點火。在零電壓切換模式下，控制器打開交流電源電壓的完整循環。觸發電路設計為盡可能接近交流正弦波穿過零點的點打開SCR。實際上，線路電壓是開著和關著的，并在整個循環中施加到加熱器上。

當輸入為4至20 mA時，Heter控制器的輸出將在4 mA以下關閉，在20 mA時完全打開。比例作用是通過改變循環次數來實現的。輸出將從低輸入時的***個循環打開和九個循環關閉到***大輸入時的所有循環打開。

SCR19可控硅功率控制器的輸出由加熱器集成，加熱器產生與輸入信號直接變化的平滑比例熱輸出。在相位角點火模式下，通過控制全交流正弦波每半個周期的開啟（點火）點來控制負載功率。